Lazer Volvo V60/S60 (2018+) Linear-18 Lower Grille Kit

See more at night and keep the front end looking right

The drive in your Volvo V60/S60 does not have to finish when the daylight does. This Lazer lighting kit gives you a clearer view ahead, with lamps positioned neatly at the front of the vehicle rather than a large exposed bar dominating its appearance.

Vehicle fitment

For V60/S60 2018+ with the specified lower-grille bumper-beam arrangement.

A lighting upgrade you will enjoy using

A useful beam is about more than a bright spot in the distance. Light across the road edges and the surrounding ground helps you read bends, entrances and uneven terrain, while the selected lamp's long-range beam extends your view ahead.

The vehicle-specific mounting arrangement holds the lights in the intended position and gives the installer a secure way to aim them. The lamp choice and operating mode determine the output and approved use; a grille mount alone does not make every lamp function road approved.

Choose the light for your journeys

Choose the mounting-only option if you already have the matching lamps. It excludes lamps and wiring. The named lamp options add the selected lamps to the vehicle-specific mounting arrangement.

Linear-18 gives you a slim bar with a broad view of the road. Standard has a lower electrical draw; Elite puts more light across the same discreet mounting position.

The Linear-18 Elite position-light option adds a white position light as well as its high beam. It has its own output and connector specification.

The i-LBA option adds Intelligent Low Beam Assist. After more than three seconds of high-beam use, it enters assist when the high beam is switched off, unless disabled with its separate switch. Its sensors respond to oncoming light and reflective signs, reducing the affected light zones. Lazer recommends mounting below 1 m for best sensor performance and keeping the lens clean. It is not an approved dipped-beam headlamp; use its approved E-Mark high-beam mode where required.

Options and part numbers

Technical specifications

Figures are for one Linear-18 lamp in the stated mode. A lux-distance is measured at the stated illumination threshold. i-LBA Boost output is separate from its approved E-Mark high beam.

Fitting your lights

For V60/S60 2018+. Fitting removes the bumper and the rubber strip on the lower impact bar, then drills 6.5 mm holes and uses the included 40 mm M6 bolts. Vehicles with factory LED headlights require a separate CAN high-beam interface. Test the trigger before any splice connection.

Fitting and high-beam connection

Follow the exact vehicle fitting instructions for the mounting position, trimming, fixing holes and cable route. Have the lamps aimed together where a pair is fitted and test the switching before use.

The electrical connection needs the correct fused supply and high-beam trigger. A compatible CAN interface is a separate installation component where the vehicle does not provide the required conventional signal. Talk to us if you would like help choosing that connection.

Looking after your lights

Keep the lenses clean and check the fixings, cable protection and electrical connections during servicing. The quoted LED design life is not a guarantee of the complete installation's lifespan, and the warranty remains subject to its terms.